Thermador Repair in San Diego
Thermador has built luxury kitchens in America since 1916, and its signatures are unmistakable: the star-shaped Star Burner that spreads the flame wider and more evenly than a round one, the ExtraLow setting that holds a true melt-and-simmer, the Freedom Induction top you can set a pan anywhere on, and the Sapphire-glow dishwasher. It's a whole kitchen — cooking, built-in refrigeration, dishwashers, and wine — and when one piece acts up it's almost always a defined repair on equipment worth keeping. From the Star Burner cooktop to the Freedom columns, we work the entire Thermador kitchen across San Diego, OEM parts and a flat $80 diagnostic credited to the job.
Meet the team behind every repair.
A whole luxury kitchen, kept running by one crew.
Thermador has been an American luxury name since 1916 and today sits inside BSH's engineering, which is why its signatures are so distinct: the Star Burner's star-shaped flame for even coverage, ExtraLow for a genuine low melt, the Freedom Induction surface that drops the burner grid entirely, and the Sapphire dishwasher. Those features are also why a Thermador rewards proper servicing — the engineering is meant to be maintained, and a fault almost always comes down to one defined part we can put right.
Most Thermador calls are contained. A Star Burner that won't light is usually its igniter or a burner cap off its seat, not the cooktop; a Freedom Induction zone that quits is typically a power module or a pan-detection fault, not a dead surface; a Sapphire that won't drain is a pump or a clogged filter. We isolate the real cause and put a price on it before any work, because on a kitchen at this level the spread between a small fix and a major one is wide and you should know which you're facing.
We carry the whole Thermador kitchen — Star Burner ranges and rangetops on our stove and range page, wall ovens on the oven page, the Sapphire dishwashers, built-in refrigeration, the wine columns, and the built-in microwaves. Parts are genuine Thermador through the authorized channel; we won't drop an aftermarket board or igniter into equipment built to these tolerances.
Thermador kitchens turn up in the homes where the whole suite was specified at once — the coastal builds in La Jolla and Del Mar and the estates of Rancho Santa Fe. We've kept both their cooking and cold sides running since 2019, the full suite under one 90-day parts-and-labor guarantee.
Reference: Official Thermador product line and owner resources
Every part of the Thermador kitchen.
Star Burner Ranges & Rangetops
Pro Grand, Pro Harmony, and Masterpiece ranges with the star-shaped burners. Igniter and burner-cap faults, the ExtraLow melt setting, convection-oven service, and porcelain repair.
Wall Ovens
Built-in single, double, and steam-and-convection wall ovens. No-heat elements and igniters, uneven baking, calibration drift, and touch-control faults.
Freedom Induction & Cooktops
The full-surface Freedom Induction top plus gas and electric cooktops. Power-module and pan-sensing faults, zone outages, and the control board behind a cooktop that won't respond.
Sapphire Dishwashers
Built-in Sapphire and Star-Sapphire dishwashers with the third rack. Won't-drain and won't-clean faults, wash-pump and spray-arm problems, and the limescale our hard water leaves on the arms and filter.
Built-In Refrigeration & Wine
Freedom built-in and column refrigerators, plus wine columns. Running-warm faults, condenser and evaporator fans, sealed-system work under EPA-608, and temperature drift in a wine unit.
What fails first in a Thermador kitchen?
| What goes wrong | Likely cause & the fix |
|---|---|
| Star Burner Won't Light | The most common Thermador call. A star-shaped burner that clicks but won't catch is almost always the igniter electrode gone dirty or cracked, a spark module that's quit, or the distinctive star cap sitting off its seat — rarely the cooktop. We clean or replace the igniter and reseat the cap so it lights evenly across the star again. |
| ExtraLow Won't Hold a Melt or Simmer | ExtraLow doesn't just lower the flame — it cycles the burner on and off to hold a melt without scorching, which is why people buy a Thermador. When it surges or drops out, the fault is usually the cycling control, the burner valve, or the orifice. We get the cycle timing right so ExtraLow melts without burning. |
| Freedom Induction Won't Heat or Faults Out | Freedom Induction is one continuous surface — dozens of inductors that sense a pan wherever you set it — so a top that won't heat or mis-maps a pan usually has a failed inverter module, a cooling-fan fault, or a sensor in the detection grid that's lost the cookware. We read the fault, test the inductor bank and the detection grid, and replace the specific module or sensor. |
| Sapphire Dishwasher Won't Drain or Clean | Standing water or filmy dishes in a Sapphire trace to the drain pump, the wash pump, or a filter and spray arms scaled by San Diego's hard water; a dead panel can be the control board. We find the cause, clear or replace it, and run a full cycle to confirm the blue glow means a clean load again. |
| Freedom Column or Built-In Drifting Warm | A Thermador Freedom column or built-in drifting warm is most often a condenser caked with San Diego's coastal air and fine dust, a tired evaporator fan, or a worn door gasket — well short of the compressor. We confirm the cause, and any sealed-system work is handled in-house under EPA-608 before we quote. |
| Wall Oven Off Temperature or Uneven | A Thermador wall oven — the steam and convection models included — running off temperature is usually the bake or broil element, the gas oven igniter, or a drifted sensor and calibration; uneven baking points to the convection fan. We trace the heat circuit, re-dial the calibration, and replace only the part that failed. |
| Wine Column Temperature Drift | A Thermador wine column that won't hold its set temperature usually needs a thermistor, a stuck damper, or a condenser cleaned — most are non-sealed-system fixes done in a single visit, so a drifting cellar rarely means the whole unit. |
What it takes to service a Thermador kitchen.
A Thermador is a luxury suite built into the cabinetry, cooking and cold side both — and one technician who can work all of it to factory standard is rarer than it should be. Here's what we bring.
A Thermador kitchen spans cooking and refrigeration, and the repairs are just as varied — a star-burner igniter is a world away from an induction board or a sealed-system job. So we price it only after the diagnosis, in writing, and the $80 carries that diagnosis whichever side of the kitchen the fault is on.
How we work on a Thermador.
Four steps to a working Thermador.
Call with the model and the symptom
Tell us which Thermador you've got — a Star Burner range, the Freedom Induction top, a Sapphire dishwasher, a built-in column — and the symptom. Call (858) 788-1552 or book online; a morning call usually books same-day.
$80 diagnostic
We test the cooking or refrigeration system the symptom points to, confirm the real cause, and hand you a written price before any work. The $80 applies to the repair.
OEM repair, often the same visit
Give us the go-ahead and we fix it with genuine Thermador parts. Star-burner igniters, dishwasher pumps, and oven elements ride on the truck; an induction board or special-order part comes with a firm date.
90-day guarantee
We back parts and labor for 90 days. A Thermador suite this well made shouldn't repeat a fault we've already fixed — and if it does inside that window, we're back to set it right at no charge.
Thermador repair — common questions.
Thermador repair across San Diego County.
Need Thermador repair in San Diego?
Luxury Thermador kitchen repair — Star Burner ranges, Freedom Induction, Sapphire dishwashers, and built-in refrigeration — with OEM parts and a flat $80 diagnostic credited toward the work. Locally owned since 2019, working discreetly across San Diego's coastal and estate kitchens.
Schedule Your Repair
Hours: Mon–Sun, 7 AM – 9 PM
(858) 788-1552📅 Book Online — Same-Day